will the late 2006 macbook pro support pny cs1311

Verified that SSD firmware is up to date (thanks to Dan for this suggestion. MacBook Pro (2006 Late 17-inch Core 2 Duo) 3s116 MacBook Pro (2006 Mid 15-inch Glossy) 3s108 MacBook Pro (2006 Mid 17-inch) 3s108 MacBook Pro (2007 Mid:Late 15-inch 2.4 2.2GHz) 3s116 MacBook Pro (2007 Mid:Late 17-inch 2.4GHz) 3s116 MacBook Pro (2008 Early 15-inch) 3s123, 3S123A MacBook Pro (2008 Early 17-inch) 3s123, 3S123A MacBook Pro (2008.

Replaced hard drive cable with new one (from eBay.).

Verified that the MBP EFI & SMC firmware are up to date.

None of these are a problem if the drive is attached by USB when attached by USB, the drive can be erased, partitioned, installed/duped to, and booted from to run OS X without issue.

If OS X is installed to the SSD, which I can do by attaching it through USB, and I try to boot, I get the question-mark folder.

If I try to erase or partition the SSD (GUID partitioned with 1 blank HSFS+ partition) using Disk Utility in the USB installer, I get the error message: 'Couldn't unmount disk.'.If I try to erase or partition the SSD (un-partitioned) using the USB installer's Disk Utility, I can see the disk but get errors like 'Couldn't read to end of disk.'.If I try to install OS X 10.11 to the SSD (GUID partitioned with 1 blank HSFS+ partition) using a USB installer, the partition on the drive is available as an installation target, but the installation fails with the error message: 'An error occurred while preparing the installation.Here are some symptoms when the SSD is attached to the HDD cable: I recently got a new SSD (PNY CS 1311 - 480 GB.) The drive itself seems good – it works fine when attached by USB to my MacBook Pro (MBP) and by USB and SATA to my PowerEdge SC440 and my girlfriend's Latitude E6540 – but I can't get my MBP to work with it when it's attached to the internal hard drive (HDD) cable.

Will the late 2006 macbook pro support pny cs1311